| 壓力檢測 / Pressure Detection | 正壓、負壓雙指示指針壓力表一個（可選數字真空計等） / One dual-indication pointer pressure gauge for positive/negative pressure (Optional digital vacuum gauge, etc.) |
| 氣體流量計 / Gas Flow Meters | 兩個浮球流量計（客戶要求精度更高時可選數字質量流量計） / Two float flowmeters (Optional digital mass flowmeters for higher accuracy per customer request) |
| 壓力保護 / Pressure Protection | 為了防止?fàn)t膛排氣口關閉，排氣口堵塞，爐膛壓力過大產生危險，特別設計此系統。原理：由電接點壓力表或者壓力傳感器獲得信號，驅動控制模塊關閉電磁進氣閥，啟動電磁排氣閥和報警器，使壓力從排氣口釋放，并觸發報警器報警。從而保護電爐的正常運行 / To prevent hazards from closed furnace exhaust port, blocked exhaust, or excessive furnace pressure, this system is specially designed. Principle: A signal from an electric contact pressure gauge or pressure sensor drives the control module to close the solenoid intake valve, activate the solenoid exhaust valve and alarm, releasing pressure from the exhaust port and sounding the alarm. This protects the furnace's normal operation. |
| 氣體泄漏報警 / Gas Leak Alarm | 根據所選用氣體，避免發生泄漏；作用：氣體泄漏報警控制器檢測室內空氣中的管路、危險性等氣體的濃度超過一定值時，驅動模塊關閉電爐，關閉氣源進氣，開啟排氣口、排風等，從而獲得更高、更安全的工作環境。（需客戶選擇） / Depending on the gas used, to prevent leaks: When the gas leak alarm controller detects the concentration of dangerous gases in the indoor air from pipelines, etc., exceeds a set value, it drives the module to shut down the furnace, close the gas intake, open the exhaust port and ventilation, etc., creating a safer working environment. (Customer optional) |
| 可使用氣體 / Usable Gases | 氧氣、氮氣、氬氣、氫氣、二氧化碳等等 / Oxygen, Nitrogen, Argon, Hydrogen, Carbon Dioxide, etc. |
| 耐火材料 / Refractory Material | 爐體使用采用進口德國MESCHUPP真空成型高純氧化鋁纖維輕質板材料，取樣物料承壓板（爐底）采用高純輕質空心氧化鋁板，使用溫度高，蓄熱量小，耐急冷急熱，不裂縫，不粉化，保溫性能好（節能效果是老式電爐的80%以上） / Furnace body uses imported German MESCHUPP vacuum-formed high-purity alumina fiber lightweight board. The material support plate (furnace bottom) uses high-purity lightweight hollow alumina board, featuring high service temperature, low heat storage, resistance to thermal shock, no cracking, no powdering, and good insulation (Energy saving effect is over 80% compared to old furnaces). |
| 保溫材料 / Insulation Material | 采用四層保溫，分別為：氧化鋁纖維毯、氧化鋁纖維板、氧化鋁多晶纖維板，進口材料，節能效果是老式電爐的80%以上。 / Four-layer insulation, consisting of: alumina fiber blanket, alumina fiber board, alumina polycrystalline fiber board. Imported materials. Energy saving effect is over 80% compared to old furnaces. |
| 爐體外殼溫度 / Furnace Shell Temperature | 長期使用不燙手，外殼溫度不大于45度 / Low external temperature during long-term use, shell temperature ≤ 45°C |
| 保護 / Protection | 采用集成化模塊控制單元，控制精度準確，并設計了雙回路控制和雙回路保護，具備了缺相、超調、欠調、斷偶、換相、超壓、超流、超溫、電流反饋、軟啟動等保護 / Integrated modular control unit ensures accurate control. Features dual-loop control and dual-loop protection, including phase loss, overshoot, undershoot, thermocouple break, phase reversal, over-voltage, over-current, over-temperature, current feedback, soft start protections, etc. |
| 控制 / Control | 采用閉環技術可控硅模塊觸發控制，控制模塊觸發控制使輸出電壓、電流或功率平滑跟隨設定曲線，具有恒電壓、恒電流或恒功率的特性，電流為內環，電壓或功率為外環，在實現負載電壓或負載電流超過額定值時，限制調整管的輸出電流在額定電流范圍內，確保發熱元件正常工作；同時電壓或功率參與調節，使調壓器的輸出電流被限制在額定電流范圍內，在有余量調節余量的前提下維持輸出電流及電壓或功率的恒定，從而達到保護發熱元件避免過大電流、電壓的沖擊，達到安全可靠的控制效果及控制精度，詳見電爐說明書 / Uses closed-loop technology with thyristor module trigger control. This control method allows the output voltage/current or power to smoothly follow the set curve. It has constant voltage, constant current, or constant power characteristics. Current serves as the inner loop, voltage/power as the outer loop. When the load voltage or current exceeds the rated value, it limits the output current to within the rated range, ensuring normal operation of the heating elements. Simultaneously, voltage/power participates in regulation, limiting the output current of the voltage regulator within the rated range, maintaining constant output current and voltage/power when sufficient regulation margin exists. This protects heating elements from excessive current/voltage impact, achieving safe, reliable control and high accuracy. See furnace manual for details. |
| 顯示參數 / Display Parameters | 溫度、溫度段號、段時間、剩余時間、輸出功率百分比、電壓、電流等 / Temperature, temperature segment number, segment time, remaining time, output power percentage, voltage, current, etc. |
| 按鈕 / Buttons | 采用高品質按鈕使用壽命超過100000次，并且增加指示燈。 / High-quality buttons with lifespan over 100,000 cycles, with added indicator lights. |
| 溫度曲線設定 / Temperature Curve Setting | 采用智能溫度控制儀，備標準PID、人工智能調節AI-PID等多種調節方式，具有自整定、自學習功能，無超調及無欠調的優良控制特性，具備30段程序控制功能，可實現任意斜率的升降控制，具有跳轉（循環）、運行、暫停及停止等可編程可操作命令，并允許在程序的控制運行中隨時修改程序，采用具備曲線平滑功能的人工智能調節算法，能獲得無需人工干預的平滑控制效果，詳見電爐說明書 / Uses intelligent temperature controller with standard PID, artificial intelligence調節 AI-PID, and other modes. Features self-tuning, self-learning function, excellent control characteristics with no overshoot/undershoot. 30-segment program control function allows arbitrary heating/cooling rate setting. Includes programmable commands like jump (loop), run, pause, stop. Allows program modification during operation. Uses AI algorithm with curve smoothing function for smooth control effect without manual intervention. See furnace manual for details. |
| 多條曲線輸入 / Multi-curve Input | 30段（可定制50段）程序控制功能，可以輸入設定：一條曲線為30段，兩條曲線14段/條，三條曲線10段/條，五條曲線6段/條；可同時輸入多條曲線，使用時可任意調用。 / 30-segment (customizable to 50 segments) program control function. Setting examples: one curve with 30 segments; two curves with 14 segments each; three curves with 10 segments each; five curves with 6 segments each. Multiple curves can be input simultaneously and called arbitrarily during use. |
